Eye of the Tiger

I hope my titles are not misleading people to view my posts for the wrong reasons lol – I just like to make them a little interesting.

Ok so Mission started and partly accomplished. I said I wouldn’t post anything until I had created some patterns and well I can’t say I finished a whole pattern but I spent at least a couple hours just doing the base work for one.

I’m quite surprised that it took as long as it did actually – just to create the grid. I took photos using my mobile (my proper camera is somewhere in a box, somewhere in my dishevelled house) so they’re not that great but the aim was to document the process.

The bare necessities

Ok so I was using large (A3) squared paper so that I would be able to keep my straight lines accurate.
I used 5cm as my radius and started drawing circles from the centre of the page outwards. This method has been demonstrated in Islamic Design: A Genius for Geometry by Daud Sutton, and is supposed to be the traditional approach to creating Islamic geometric patterns. If you’ve read my Project justification then you’ll know why this is important to me. As it isn’t my usual method I thought I’d give it a go and see where it takes me.

Ok so the circles start overlapping as seen below:

circles overlapping but spreading too

I then carried on until I had filled the whole page with the circles:

As you can see this has created a tessellated effect simply with the construction of circles. After this I wasn’t quite sure what I needed to do next. I misplaced my book 😦 and so I played it by ear – well tried to remember what I had read in the book anyway. As I’ve said before I havn’t got access to my stuff.

So then I started connecting the mid points of each circle – creating horizontal, vertical and diagonal lines – a sub grid.

This produced another set of shapes on the sub grid of lines not just the circles. I’m not sure that the vertical lines were correct but it looked ok so I carried on:

Adding lines

I looked closely at the page (which was a bit mesmerising) and picked out shapes that I liked the look of. I usually do this in the creation of my pattern work. Breaking down shapes using lines and particular measurements and then seeing what new shapes are created. In the close up below you can see some of these smaller shapes within shapes which were created simply by the addition of the straight lines. I would now need to consider which shapes I would choose to highlight and use in the pattern and which ones would perhaps form a subtle background to the main pattern.

The shapes

Ok so I think this process was useful. The main thing that I found difficult was the accuracy! Even though I made sure the compass stayed at the same radius throughout, and that the connecting lines and dots and movement from one circle to another was the right place, there were still wider spaces between shapes than there should have been. The most annoying thing I found was the compass kept slipping!!! this was highly irritating and meant I had to rub out bits here and there.

But it’s been a learning process and I need to do this a lot more so I know how to neaten up my grids and start doing different kinds of patterns. I am really looking forward to the next stages of these experiments.

Now I really need to find that book!!

Advertisement

Explore posts in the same categories: experimentation, Ideas for project outcome

Tags: compass, Daud Sutton, experiment, formations, Geometry, grid, learning, lines, patterns, pencil, process, rubber, ruler, shapes

You can comment below, or link to this permanent URL from your own site.